2006-2007 BMW K1200GT Installation Instructions
Repositions the stock handlebars 1” (25mm) closer to the rider from their tallest adjusted position. No height adjustments are possible with the HR adapter as it maintains the tallest bar position....
View Article2005-2008 Ford Mustang GT 4.6L V8 Installation Instructions
Start by disconnecting the wire harness from the MAF sensor as shown. Next loosen the hose clamp on the stock air tube to the air box as shown. Remove the stock air tube from the stock air box as...
View Article2005-2008 Ford Mustang 4.0L V6 Installation Instructions
1. Start by disconnecting the wire harness from the MAF sensor as shown. 2. Next loosen the hose clamp on the stock air tube to the air box as shown. 3. Remove the stock air tube from the stock air box...
View Article1999-2007 Chevy/GMC 4.8/5.3/6.0L Mac Performance Installation Instructions
1. Start by loosening the hose clamp from the stock air tube to the throttle body as shown. 2. Remove the clip from the located on the coolant hose to the stock air tube as shown. 3. Loosen the hose...
View Article2007 Cadillac Escalade 6.2L AWD Cat-Back Dual Extreme Exhaust Installation...
When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the vehicle, set parking brake, block tires and use safety glasses and gloves. Allow...
View Article2007 Cadillac Escalade 6.2L AWD 4dr Cat-Back Single Exhaust Installation...
When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the vehicle, set parking brake, block tires and use safety glasses and gloves. Allow...
View Article07-08 GMC Sierra Denali 1500, 6.2L, 2wd Cat-Back Stainless Dual Extreme...
When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the vehicle, set parking brake, block tires and use safety glasses and gloves. Allow...
View Article2007-2008 Chevrolet & GMC Truck with a 5.3L, 6.0L & 6.2L V8 Mac Performance...
1. Start by disconnecting the wire harness from the MAF sensor as shown. 2. Remove the cover from the intake manifold by lifting it up and then pulling it out as shown. 3. Unplug the vent air tube from...
View ArticleDYNA Ignition Coil Installation Instructions
For breaker points, the 5 ohm coils should be used or the 3 ohm coils can be used and a 1 to 2 ohm ballast resistor placed in the 12 volt line going to the coils. Generally, a ballast resistor should...
View Article2003-2006 Hummer H2 6.0L V8 Part #3060 Installation Instructions
1. Start by unplugging the MAF sensor by using a screw driver to remove the clip as shown. 2. Push fitting in and pull up to remove the wire harness from the MAF sensor. 3. Remove the bolts that hold...
View Article
